Efeito Cerâmico
Efecto Iridiscente
Gold Ice Effect
Decorative three-dimensional effect similar to frost or ice.
Original 3D visual effect.
The application of the process following the guidelines of the notes that we describe in the process, is important for the achievement of the result.
GOLD ICE EFFECT PROCESS
Step 1: Preparation of the support
Over MDF-boards.
Application of a layer of 250 – 300 g/m2 of PU Primer or Transparent Polyester or coloured.
Let dry.
Application of a layer of 250 – 300 g/m2 of PU Primer or Transparent Polyester or coloured.
Let dry.
Step 2: Sanding and ice effect
Sand within 24 hours. Clean the surface with a cloth moistened with water.
Apply a layer of AH-1004 Ice Effect between 60 – 100 g/m2.
The higher the grammage, the greater the relief of the effect.
Let dry for 24 hours at normal ambient conditions.
Apply a layer of AH-1004 Ice Effect between 60 – 100 g/m2.
The higher the grammage, the greater the relief of the effect.
Let dry for 24 hours at normal ambient conditions.
Step 3: Application of the decoration
Apply a decorative product, such as chrome cover PM-1340 or the range of metallized topcoats PM-1700/YY.
It can also be applied a coloured lacquer, it is recommended an acrylic topcoat.
Let dry for 12 hours.
It can also be applied a coloured lacquer, it is recommended an acrylic topcoat.
Let dry for 12 hours.
Step 4: Topcoat
Apply a layer of PM-100 Chrome Protector (+5% RP-045) of 120-150.
It can also be applied other transparent acrylic topcoats (consult the Technical Department).
It can also be applied other transparent acrylic topcoats (consult the Technical Department).
