Flourescentes
Eurosalqui cumple 30 años
Corten Steel Verdigris
Process that transforms a surface into bicolor corten steel, with a high aesthetic value that also protects the surface from corrossion.
The application of the process following the guidelines of the notes that we describe in the process, is important for the achievement of the result.
PROCESO ACERO CORTEN
Paso 1: Preparación del soporte
On surfaces such as MDF or wood, it is recommended to apply a pigmented base such as FC-571 WHITE PUR SEALER.
Let dry for 24 hours.
Surface sanding with 280 – 320 grit.
Let dry for 24 hours.
Surface sanding with 280 – 320 grit.
For other surfaces, ask to our technical department for other posible products to be used as first layer, to guarantee adhesions.
Step 2: Steel based application
Apply HM-6005/80 180 – 250 g/m2. Product can be diluted with water (30 – 100 %).
Let dry for 18 hours under normal conditions of humidity and temperature.
Once dry, sand with very fine grain (400 – 600).
Let dry for 18 hours under normal conditions of humidity and temperature.
Once dry, sand with very fine grain (400 – 600).
Step 3: AQ-600 Application of activator
Apply AQ-500 between 50 – 60 gr/m2. You can use a sprayer, gun or brush.
Let dry for 20’.
Let dry for 20’.
Step 5: Transparent insulating primer IH-001
Without sanding and once the required oxidation has been obtained,
we avoid the posible change of tone by applying one layer of IH-001.
Apply between 40 – 80 g/m2. Let dry.
Application of a final protection, depending of the final use for this decorational effect.
we avoid the posible change of tone by applying one layer of IH-001.
Apply between 40 – 80 g/m2. Let dry.
Application of a final protection, depending of the final use for this decorational effect.
